Cut a piece of fleece that is 1" long and 1/2" wide. Peel the protection strip and fold the fleece over the top of the launcher as shown at left.   Using scissors, snip the V back out of the fleece to match the V in the launcher. *NOTE: Do not trim the fleece too close to the edges of the launcher.   Trim any excess fleece from the outside edges of the launcher.   Cut a piece of fleece that is 1-1/2" long by 3/4" wide. Beginning on the outer edge of guide stick the fleece firmly to the surface and work your way up the side.   Using a pen, or piece of arrow shaft, roll the fleece over the edge and down into the groove. Be sure to keep the adhesive from touching the far side of the groove as you firmly depress the fleece into the groove.   Work your way up over the top of the groove and down the side of the guide. Trim any excess fleece with scissors.